ESP32/ESP8266 Flasher
Flash Espressif chips through their serial download mode, as esptool does: the ESP32, ESP32-S2, -S3, -C2, -C3, -C5, -C6, -C61, -H2, -P4 and the ESP8266. Through a USB-to-serial converter or the built-in USB port of the newer chips, with automatic reset on most boards. Bootloader, partition table and program go to their addresses and are checked afterwards.
Firmware
| File | Size | Address | Remove |
|---|
Choose Flash firmware and select the board's serial port. The app resets the chip into download mode, writes the files and checks each one with an MD5 sum computed by the chip (not possible on the ESP8266).
Chip
Shows the chip type, MAC address, flash chip and its size, and the security settings.
Erases the whole flash, including Wi-Fi settings and stored data (NVS).
Restarts the chip through the reset line so that it runs its program.
Download mode
- Development boards (DevKit, NodeMCU, Wemos D1 and most others) have an auto-reset circuit: DTR and RTS of the converter pull IO0 (GPIO0) and EN, so the app starts the download mode by itself.
- Built-in USB of the ESP32-C3, -C5, -C6, -C61, -H2, -P4 and -S3 (USB-Serial/JTAG): connect the chip's USB pins directly; the reset works the same way through the USB port.
- By hand: hold BOOT (GPIO0 on the ESP32, -S2, -S3 and ESP8266, GPIO9 on most C- and H-series chips), press and release RESET (EN), release BOOT. Then choose “Reset: by hand” under More options.
- ESP32-S2 with native USB: enter the download mode by hand; the chip then appears as a new serial port. Press RESET after flashing.
Bare modules need a 3.3 V converter: TXD to RXD0 (U0RXD), RXD to TXD0 (U0TXD), GND to GND, and a supply that can deliver at least 300 mA.