Hex Editor
Look into firmware files and change single bytes: BIN, Intel HEX, S-record, UF2 and ELF with its segments, sections and symbols. Search for bytes or text, read values with the data inspector, check CRCs, and save the result in any of these formats, for example an ELF as HEX for the programmer.
No file yet. Open a BIN, HEX, S-record, UF2 or ELF file, or drop it here.
Good to know
- Formats: Intel HEX and S-records with all address records, UF2 (also with family), ELF (32 and 64 bit, Arm, RISC-V, AVR, …) and anything else as binary. The format is detected from the content; Read as Binary shows a HEX file as text bytes.
- ELF: the image shows the loadable segments at their load addresses, as
objcopywrites them for the programmer; File shows the ELF file itself. Both edit the same bytes, and ELF (changed) saves the file with the changes. Click a symbol to go to it. - Saving: only the ticked regions are saved. Binary fills the gaps between regions; a binary starts at the lowest address saved.
- Editing: click a byte, then type hex digits (or text in the right column; Tab switches). Shift with arrows or mouse selects; Ctrl+Z and Ctrl+Y undo and redo; Ctrl+A selects everything; Ctrl+C copies the selection as hex. Changed bytes are marked.
- Search: hex bytes with
??for any byte, or text; Enter finds the next one. Go to takes an address in hex (0x0800 0000,8000000) or a symbol name. - Checksums cover the selection, or all ticked regions when only one byte is selected; gaps are left out.