C64 Tape Transfer
Read a cassette from the Datasette into a TAP file, write a TAP file back to tape, look at every pulse and clean up worn recordings. Works with the TapeBuddy64, TapeDump64 (read only) and DumpMaster64.
Rewind the cassette, choose Read tape, then press PLAY on the Datasette within 10 seconds. Reading ends when you press STOP, at the end of the tape or after 25 seconds without signal.
Open or read a TAP file first; it is written exactly as shown in the pulse view.
Choose Write to tape, then press RECORD and PLAY on the Datasette within 10 seconds.
Pulses
Pulse lengths appear here while a tape is read or when a TAP file is opened.
- Other loaders
- ROM loader pilot
- ROM loader header
- ROM loader data
- Damaged block
- Longer than 0x80 (pauses), drawn at the top
Pulse lengths
Tape contents
Files saved with the standard C64 ROM loader are listed here. Turbo loaders show up in the pulse view only.
| Position | Name | Type | Address | Bytes | Check |
|---|
Optimize
Cleans up a recording, similar to TAPClean but limited to what works for any tape: ROM loader files are fully understood, other loaders are cleaned by pulse statistics.