XGecu Memory Programmer

Read, write and verify EPROMs, EEPROMs and flash memory (parallel, SPI, I2C, Microwire, DataFlash, FWH/LPC) with an XGecu TL866A, TL866CS, TL866II+ or T48. Choose the chip from over 22,000 names, or let the app detect an SPI flash by itself.

Chip

Loading the chip database …

Write and verify

    Write erases an electrically erasable chip first (code memory), writes the file (rounded up to whole blocks and padded with the blank value) and verifies it. UV-EPROMs must be blank. Verify compares the chip with the file.

    Read and erase

    Reads the whole memory and saves it as a BIN file.

    Checks that every byte has the blank value (0xFF on most chips).

    Erases an electrically erasable chip (EEPROM, flash). UV-EPROMs are erased with UV light.

    Inserting the chip

    Pin 1 of the ZIF socket is at the top left, next to the lever. A DIP chip sits at the top of the socket, next to the lever, with its notch and pin 1 pointing up towards the lever, as Xgpro shows it: chip pin 1 goes into socket pin 1 and the last chip pin into socket pin 40. A DIP8 uses the top four rows, a DIP28 the top 14 rows, a DIP40 the whole socket. Close the lever before any action.

    Chips in other packages need an adapter. SOIC, SOP, TSSOP, WSON and similar packages go into a package-to-DIP adapter (or a test clip), which is inserted like a DIP chip of the same pin count. PLCC chips need a PLCC to DIP adapter. TSOP32/40/48, SOP44 and SOP56 chips need the matching XGecu adapter. The TL866A/CS and TL866II+ check that a TSOP48, SOP44 or SOP56 adapter is there.

    A chip inserted the wrong way round can be damaged. The programmer switches off and reports overcurrent if it detects a short.