Take out the battery or switch the console off while it is powered by the WCH-LinkE.
Setup and link mode
The WCH-Link must be in RISC-V mode: its blue LED is off. If the blue LED is on, connect it and choose Switch to RISC-V mode, or hold the ModeS button while plugging it in.
Windows: install the WinUSB driver for the WCH-Link's debug interface (not the serial port) with Zadig.
Linux: allow access to the device:
echo 'SUBSYSTEM=="usb", ATTR{idVendor}=="1a86", ATTR{idProduct}=="8010", MODE="666"' | sudo tee /etc/udev/rules.d/99-WCH-LinkE.rules
echo 'SUBSYSTEM=="usb", ATTR{idVendor}=="1a86", ATTR{idProduct}=="8012", MODE="666"' | sudo tee -a /etc/udev/rules.d/99-WCH-LinkE.rules
sudo udevadm control --reload-rules
For other WCH chips, erasing, unlocking or unbricking use the WCH RISC-V Programmer.